Herein, we report two cases who had endoleaks after EVAR and were successfully treated with computed tomography (CT)-guided thrombin injection. To the best of our knowledge, these are the first reported cases in the literature.
We performed percutaneous CT-guided thrombin injection preserving the coil embolization as the second option, if failed. We put the patient in the prone position on CT table and, then, we marked the entry point with a metallic marker. Under standard sterile conditions, 20 mL prilocaine hydrochloride as a local anesthetic agent was administered. Then, we reached the saccular space from the right posterior paravertebral region using a 22-gauge 20 cm Chiba needle (Geotek Medical, Ankara, Turkey). Once the tip of the needle was confirmed in the right place, we slowly injected 2 mL thrombin (Tisseel, Baxter, Austria) to the space. The duration of the procedure was 12 minutes. The patient was uneventfully followed by CT angiography at one and 12 months after the procedure. The diameter of the aneurysm decreased 8 mm at 12 months (from 90 mm to 82 mm). The patient is still uneventful (Figure 1b).
Case 2– A 60-year-old male patient had an infrarenal
abdominal aortic aneurysm in 2013. The length
of aneurysm neck was 80 mm and the neck angle
was 45°. The diameter was 79 mm. The EVAR
procedure was performed at another center. Repeated
CT angiography showed type 1b endoleak from the left iliac limb. He, then, underwent re-intervention to
treat endoleak at the same center and a limb-extending
graft was deployed without embolization of the left
internal iliac artery. At three months, repeated CT
angiography showed persistent endoleak from the left
internal iliac artery (Figure
We performed percutaneous CT-guided thrombin
injection. We used the transperitoneal approach.
We put the patient in the supine position on
CT table, and, then, we marked the entry point
with a metallic marker. Under standard sterile
conditions, 20 mL prilocaine hydrochloride as a
local anesthetic agent was administered. Then,
we reached the left common iliac artery using a
22-gauge Chiba needle (Geotek Medical, Ankara,
Turkey), positioning the needle tip between the
native arterial lumen and graft (Figure 2b). Once the
tip of the needle was confirmed in the right place,
we slowly injected 2 mL thrombin (Tisseel, Baxter,
Austria) to the space. The duration of the procedure
was 16 minutes. The patient was uneventfully
followed by CT angiography at one and six months
after the procedure (Figure 2c). At six months,
CT angiography showed that the diameter of the
aneurysm was 76 mm (79 mm preoperatively).
Embolization techniques were originally introduced for treating type 1 endoleaks.[4] Recently, the use of micro-coils and liquid embolic agents (n-butyl 2-cyanoacrylate or ethylene vinyl alcohol copolymer) have been increasingly utilized in the treatment of treat type 1 endoleaks.[4-6]
In our both cases, we performed percutaneous CT-guided thrombin injection for the treatment of endoleaks. Standard techniques such as cuff, coil embolization or others might be also performed in Case 1. However, we performed the first option upon the preference of the patient, after informing him on both treatment modalities. For the surgeons, the reason for choosing this practical unproven treatment option was the existing anatomic structures. In Case 1, there was a suitable saccular space, posterior to the graft fixation zone, between the aneurysm sac and stent-graft. However, there was no other endovascular treatment option in Case 2. The main question is that: although we were able to use other liquid embolic agents (n-butyl 2-cyanoacrylate or ethylene vinyl alcohol copolymer), why did we prefer thrombin for embolization? The answer lies in the following facts: First, as thrombin is a ready to use agent for use, it does not require a special preparation. Second, as it does not cause non-target embolization and beam hardening artifacts on CT angiography, it does not limit the diagnostic imaging during follow-up.
The other major advantages are (i) lower radiation exposure than other endovascular treatment procedures both for patient and surgeon, (ii) lower procedural costs, (iii) shorter procedural time, and (iv) suitability in an outpatient setting.
In the published reports, embolization with thrombin, glue, and ethylene-vinyl alcohol copolymer was effectively performed for type 2 endoleaks with satisfactory long-term results.[7] However, there is no study with thrombin for type 1 endoleaks. The main goal of standard techniques such as coil embolization is to prevent the flow to the aneurysm sac.[7] There are also several reports of thrombosis with coils.[7] In our cases, we performed thrombosis with thrombin and we observed no significant difference in the risk for growing aneurysm size and rupture between our technique and standard techniques.
In conclusion, as a safe, effective, and costeffective treatment modality, percutaneous computed tomography-guided thrombin injection for the treatment of endoleaks should be considered as an alternative practical treatment option in eligible patients.
Declaration of conflicting interests
The authors declared no conflicts of interest with respect to
the authorship and/or publication of this article.
Funding
The authors received no financial support for the research
and/or authorship of this article.
1) van Marrewijk C, Buth J, Harris PL, Norgren L, Nevelsteen
A, Wyatt MG. Significance of endoleaks after endovascular
repair of abdominal aortic aneurysms: The EUROSTAR
experience. J Vasc Surg 2002;35:461-73.
2) Parıldar M, Posacıoğlu H. Endovasküler aortik anevrizma
tamiri sonrası görülen kaçaklar (endoleak): Tanım ve tedavi.
Turk Gogus Kalp Dama 2011;19:46-50.
3) Kasthuri RS, Stivaros SM, Gavan D. Percutaneous
ultrasound-guided thrombin injection for endoleaks: an
alternative. Cardiovasc Intervent Radiol 2005;28:110-2.
4) Rosen RJ, Green RM. Endoleak management following
endovascular aneurysm repair. J Vasc Interv Radiol
2008;19:37-43.
5) Maldonado TS, Rosen RJ, Rockman CB, Adelman MA,
Bajakian D, Jacobowitz GR, et al. Initial successful
management of type I endoleak after endovascular aortic
aneurysm repair with n-butyl cyanoacrylate adhesive. J Vasc
Surg 2003;38:664-70.